 |
 |
Step 1:
-聽聽聽聽聽聽聽聽聽 Remove door panel, OEM speaker and OEM factory radio and insulate door panel with Dynamat.
-聽聽聽聽聽聽聽聽聽 Air vents are also removed in order to remove factory radio.
 |
 |
 |
Step 2:
-聽聽聽聽聽聽聽聽聽 Kicker in-line fuse holder is installed.
Step 3:
-聽聽聽聽聽聽聽聽聽 聽The spare tire is removed and the RCA cables and power cables are ran to the rear of the car.
 |
 |
 |
Step 4:
-聽聽聽聽聽聽聽聽聽 Dynamat is put into trunk to insulate from noise rattle.
-聽聽聽聽聽聽聽聽聽 Custom sub box and amp tray using 戮 MDF wood is planed into trunk.
-聽聽聽聽聽聽聽聽聽 A red LED light is also installed for effect.
Step 5:
-聽聽聽聽聽聽聽聽聽 White vinyl is placed over speaker box and amp tray to match car exterior.
 |
 |
Step 6:
-聽聽聽聽聽聽聽聽聽 Speaker wire that has been fed through to trunk is hooked up to Kicker subs.
-聽聽聽聽聽聽聽聽聽 Kicker subs are placed and mounted into speaker box.
-聽聽聽聽聽聽聽聽聽 The trim is wrapped in suede.
 |
 |
Step 7:
-聽聽聽聽聽聽聽聽聽 Custom back trim is cut to cover the gap between the trunk set up and the back seats.
-聽聽聽聽聽聽聽聽聽 The custom top trim is made from 录 MDF wood and covered in suede.
Step 8:
-聽聽聽聽聽聽聽聽聽 Custom fiberglass is fastened to top of trunk to mount 鈥�20 Hertz Audio鈥� logo.
